The SMART 50M is a versatile oil in water monitor suitable for high temperature and pressure in both marine and industrial applications.
The SMART 50M is a versatile and sophisticated oil-in-water detector. The monitor is designed for high temperature and high-pressure sample measurements in marine and industrial applications, across multiple ranges of oil concentration.
The monitor has two versions available to suit different oil ranges – low and medium. Combined with proprietary measuring cell, autoclean capability and auto-zeroing functionality, this oil-in water detector has minimal maintenance requirements, producing highly accurate measurements consistently, as the measuring cell is kept free from fouling.
The oil-in-water detector uses a nephelometry based detection technique and sophisticated algorithms to detect oil content in the sample stream.
An internal data recorder will log the following data – oil concentration, sample pressure, sample temperature, fault status alarm and run status.
The Smart 50M can provide the Oil Concentration value to a DCS or PLC using a 4-20mA output.
As standard the following data is available :
- Oil Concentration
- Sample Pressure
- Sample Temperature
- Fault Status
- Alarm and Run states
Oil in Water Detector Applications
- Hydrocarbon Leak Detection
- Lube Oil Cooler Monitoring
- Boiler Feed Protection
Heat Exchanger Leak Detection
Industrial Wastewater/Groundwater discharge.
Oil in Water Detector Specification
| Ranges : | Low range 0 – 10ppm |
| Medium range 0 – 200ppm | |
| Accuracy : | Low range +/- 0.5ppm |
| Medium range +/- 5 ppm | |
| Alarm 1 Operating Point : | Low range 1 – 10 ppm |
| Medium range 1 – 200 ppm | |
| Alarm 2 Operating Point : | Low range 1 – 10 ppm |
| Medium range 1 – 200 ppm | |
| Alarm 1 Operating Delay : | 1 – 15 seconds |
| Alarm 2 Operating Delay : | 1 – 600 seconds |
| Alarm contact rating : | 8 AMP @230VAC |
| Output signal : | 4-20 mA |
| Ambient temperature : | 1-60 °C / 34 – 122 F |
| Humidity : | Max 98% non condensing |
| Sample temperature : | 1 – 95 °C / 34-203 F |
| Sample Flow : | 0.3 – 3 Ltrs per min / 0.079 – 0.79 Gal per min |
| Sample Pressure : | 1.0 Bar Minimum / 14.50 Psi |
| 3.0 Bar Nominal / 43.50 Psi | |
| Clean Water requirements : | 0.3 – 3L per min / 0.079 – 0.79 Gal per min for ‘zeroing’ |
| Weight : | 15kg / 33.07 lb |
| Size : | 500 x 360 x 150mm / 19.7” x 14.2” x 5.9” |
| Supply voltage : | 115 – 230 VAC |
| Power consumption : | 15 VA |
| Degree of Protection : | IP56 |
| Approvals : | Tested to EN61010 EN61326 (CE), c UL us. |
Read more :
